ArcSAP Default Password

The ArcSAP default password is  0000 .  You will need this password in order to create/delete RaidSets and Volumes. 

When using advanced features through the web browser you will be asked a user name.  The default username is "admin" and the password is "0000"

      

• Related Articles

• ArcSAP RAID Configuration Software

  The ArcsSAP software will be needed when configuring RAID. ArcSAP macOS Installer ArcSAP Windows Installer ArcSAP Manual

• Lost Password on M3000 Library Recovery

  Recovery Instructions attached below:

• RAID/Pass-Through Configuration

  ArcSAP is the software to configure RAID and Pass-Through devices from the MagStor LRU to your host operating system. Once connected you will be able to configure RAID and LTO tape drive visibility to your operating system. The ArcSAP default ...

• Creating a RAID set and RAID volume

  The disks will be inaccessible to the host operating system until a RAID or pass through device is configured. Download and install ARCSAP controller software. ArcSAP RAID Configuration Software : Technical Support Portal (freshdesk.com) Once ...

• (Intel MAC) Thunderbolt 3 (Rev C) LTO drives not responding

  This fix is for Intel-based MACs on first setup of a Thunderbolt LTO drive (Rev C) where the drivers have been installed and the LTO drive(s) are detected by the system. In the event you can detect LTO drives on your Intel based MAC, but cannot issue ...