RAID/Pass-Through Configuration
ArcSAP is the software to configure RAID and Pass-Through devices from the MagStor LRU to your host operating system. Once connected you will be able to configure RAID and LTO tape drive visibility to your operating system.
The ArcSAP default password is 0000 . You will need this password in order to create/delete RaidSets and Volumes.
ArcSAP Software Download
macOS 10.12 or higher (Intel/Apple M1)
User manual
Configuration instructions
Related Articles
Creating a RAID set and RAID volume
The disks will be inaccessible to the host operating system until a RAID or pass through device is configured. Download and install ARCSAP controller software. ArcSAP RAID Configuration Software : Technical Support Portal (freshdesk.com) Once ...LTO Drive Pass-Through Configuration
If you need to configure a tape drive or a single SSD for operating system access it will need to be configured as a "Pass-through disk". Open the Arcsap utility and select the "ARC-1886-8I" Device under "LocalHost". Right click and select "New ...ArcSAP RAID Configuration Software
The ArcsSAP software will be needed when configuring RAID. ArcSAP macOS Installer ArcSAP Windows Installer ArcSAP ManualLRU Thunderbolt-3 LTOx RAID
Before installing a correct driver, there are few steps that need to be done depending on what kind of Mac hardware you have. there are three major hardware variations: a. M1 based b. Intel based with T2 security chip c. Intel based without T2 ...HDD not seen in TRB3 Removable Hard Drive Bay
HDD not seen in TRB3 removable drive bay The underlying HBA within our TRB3 had RAID abilities by default. If needed, you must clear the existing configuration and reset the HBA to a JBOD configuration to see the hard disks used in the removable, ...